MirrorTap, MT-1015, 15″ Radar Detector Power Cord with 2AMP Inline Fuse, Audi Tap Size, RJ11 Plug

No More coiled cigarette lighter power cords. The MirrorTap Power Cord simply plugs into any wire harness close to your AUTO DIMMING MIRROR, whether it be exposed on the rear face of the mirror (most common application), or inside the Wire Cover at your windshield (2010 & newer Camaros, and many 2012 & newer vehicles), or inside the Headliner (Acura TL, and very few others). No cutting or splicing wires and No Messin with the Air Bags inside your A-pillar as is done with regular hardwire installations to the fuse box under the Dash. Guidelines on Using a Voltmeter to Locate Power and Ground: (#1) First set your voltmeter to the continuity setting (should beep when you touch the red and black probes together, telling you they are shorted) (#2) Find a ground on the car somewhere, like a bolt under the dash, or a metal cross member. (#3) Put the black probe on that ground, and touch the back of each exposed wire connector in the mirror harness with the red probe. (#4) For each wire that beeps, that means that wire is grounded. Turn the ignition to the on position, then back to off, and make sure it beeps regardless of ignition position. (#5) Put the voltmeter into VDC mode, to measure DC volts, turn the ignition to the on position. (#6) Put the black probe on the ground wire found in #4. (#7) Touch each of the wires in that harness with the red probe, and note which one(s) gives you +12-14 volts, turn the ignition off to verify that the volt readings go down to zero or close to zero. (Finally) That should define which two ports in that harness into which you would plug the MirrorTap, the black Prong into #4 above, and the Red to #7.

Product Features

  • No Worries, We message every Amazon Customer for their vehicle/radar info to determine the Correct Version to ship, thus the 3-day handling time

Get More Detailed Information About This Product…

Tagged , , , , , , , , , , , , . Bookmark the permalink.

2 Responses to MirrorTap, MT-1015, 15″ Radar Detector Power Cord with 2AMP Inline Fuse, Audi Tap Size, RJ11 Plug

  1. Anonymous says:

    This mirror tap was perfect for my 2015 Audi Q5. Pop off the upper cord cover. Disconnect 5 wire plug. Insert red tap in black w/red trace wire. Insert black tap in brown wire. Reconnect plug and put back into holder. Use included wire tie to secure cord to wiring above plug. Cut off excess wire tie. Route cord to right. Put cord cover into place, and secure as was before you started. Plug into your radar detector. Tuck excess cord away. You now have clean, hidden power to your…